1、火焰加熱器加熱卷材要均勻，不得過分加熱或燒穿卷材；
1, flame heater heating coil should be uniform, not excessive heating or burning through the coil;

2、卷材外觀熱熔后要立即滾鋪卷材，卷材下面的空氣排盡，并用輥軸壓粘牢固，不得空鼓；
2, the surface of membrane melt immediately after rolling CARPT coil, coil below the air exhaust, and the roller press firmly, not hollowing;

3、卷材接縫部位必須溢出熱熔的改性瀝青膠；

3, the coil joints must overflow hot melt modified asphalt rubber;

4、鋪貼應卷材平整順直，搭接尺寸正確，不得扭曲、皺折；
4, Putie should be roll flat straight, lap size is accurate, no distortion, wrinkle;

5、泛水和立面卷材收頭的端部應裁齊關鍵詞優化，塞入預留的凹槽內，用金屬壓條釘壓固定(成都人事考試中心)，最大釘距不大于500mm，上口用聚氨酯嵌填封嚴；
At the end of 5, water and facade coiled material should be cut together, into the reserved grooves, with metal layering nail fixed pressure, the largest nail margin of not more than 500mm, is using polyurethane block filled seal;

6、屋面消防墩在卷材施工前外觀滿刷2.0mm厚聚氨酯，卷材上翻300mm高；
6, roof fire pier in the construction of the surface before the full brush 2.0mm thick polyurethane, roll up 300mm high;

7、卷材粘貼完成，面滿鋪無紡布。
7, coil paste is completed, the surface is full of non-woven fabrics.

本文由上海專業屋頂防水整頓發布，若貴單位需要屋頂防水維護方案，我們專業提供分享。